Plugging Hole On Van Roof Solar

Fasten the 4 hole square washers to the front most holes of the rear panel and the back most holes of the front panel connecting them together.

Plugging hole on van roof solar.

And on your roof rack you need to locate at least two or more holes than you can fasten your solar array to. If you say freedom we say solar power. Line up the spring nuts on the inside of the strut channel with the center of each hole of you square washers. Using a hole saw attached to our power drill we drilled two holes in the roof for the positive and negative wires.

It also makes them lightweight. How to install solar panels on a camper van conversion with 3m vhb tape no holes solar panels are a key element for off the grid vanlife. Put the solar panels on top of your van where you d like them to be installed renogy solar panels installed on my van. It was a snug fit but they went in nicely.

So let s say you want to use the threaded hole you would have to remove the paint and the rubber plug. Two holes were drilled in the back of the van right above the back most roof beam to feed the solar cable into the van. If you climb on your transit roof you won t find any of these threaded holes because they come with rubber plug and ford simply painted over them. Once we filed them through the two ports on the cable entry mount we filed them down into the van.

These threaded holes are used to install roof rack and such. Rigid solar panels are the best bang for your buck when it comes to performance and durability. Carry your solar panels to the roof and plug in your positive and negative connections. Most roof racks will come with at least four or more such attachment holes but many roof racks come with 6 or 8 such attachment points.

I had the general idea of where i wanted the solar panels to sit on top of my van but without dry fitting them first i would have overlooked how the mounting holes actually lined up on the contoured roof. To do this you need a roof rack on the top of your car truck or van. I used the renogy y adapters to connect the two panels in parallel. Because they don t have a frame they are low profile and can bend to shallow curves such as a van roof.

Then i cut the 30 foot mc4 cable in half and attached each y adapter to it s mating end of the cable halves.